材质在室内设计中的情感体现

人们对室内空间的需求除功能需求外,逐渐往精神需求发展。而满足这种需求,关键在于对室内装饰材质的运用。不同的材质具有不同的性格,给予人不同的情感体验。正确的认识二者的关系,才能使材质在室内装饰设计中充分满足人们的情感需求,以便营造出更为舒适的室内环境。     

基于形变模型的多视图三维人脸重建

本文提出了基于形变模型的多视图三维人脸重建方法,将人脸形变模型与同一人脸在不同视点下的多幅图像进行匹配,从而重建出具有较强真实感的三维人脸模型。本文将对基于形变模型的多视图三维人脸重建方法进行详细的阐述,并把实验结果与单视图重建出的三维人脸模型进行了对比,从而体现出多视图重建的优势所在。     

Mechanical Properties of Textured Alumina Made by High-Temperature Deformation

The mechanical properties of a textured alumina made by high-temperature deformation of normal-purity sintered alumina have been investigated. The textured alumina shows very high bending strength and extremely high fracture toughness. Fracture toughness of more than 10 MPa·m^1/2 was measured by the single-edge precracked beam method, and even using the single-edge V-notched beam method, toughness of over 8 MPa·m^1/2 was obtained. This high fracture toughness was attributed to a large number of aligned small platelike grains of the textured structure enhancing the grain bridging effect.     

基于概率神经网络的人群密度估计

研究图像在频域中的纹理特性,实现了在频域中的人群密度估计.首先,对视频的每一帧进行离散余弦变换(DCT),将视频图像的空域性质转化到频域中;其次,统计分析视频图像DCT变换矩阵的纹理特性,提取能描述不同密度等级的纹理描述子作为特征向量;最后,用提取出的特征向量训练概率神经网络,并进行人群密度等级估计.实验表明,该方法可以很好地进行密度估计,获得了较高识别效率.     

Hot-compression behavior of Al-1Mn-1Mg alloy

The hot-compression of Al-1Mn-1Mg (mass fraction, %) alloy sample was carried out on a Gleeble-1500 thermo-simulator at deformation temperatures from 320 to 400 ℃ and strain rates from 0.1 to 10 s-1 by total strain of 1.4. Microstructure and texture evolution of the hot-compressed alloy were investigated by optical microscopy and X-ray diffraction analysis, respectively. The results show that the relationship among flow stress σ, deformation temperature T and strain rate ε can be expressed in the form of βσ...     

Mechanical performance and texture characteristic of an IF steel containing Nb and Ti by double cold rolling

Single cold rolling and double cold rolling were applied to hot rolled strips with different reduction ratios. The evolutions of {100},{111} and Goss face texture during double rolling were investigated by comparing the orientation distribution function(ODF) of the double rolled sample with that of the single rolled one. The double cold rolling texture is characterized by a higher γ-texture and a lower α-texture,and the {111}<112> component is improved remarkably. Based on the TEM observation and mechanical...     

胶结物对东营凹陷储层砂岩弹性特征的影响

储层岩石的地震弹性属性是进行油气储层勘探及动态监测的基础。系统选取东营凹陷古近系各层段砂岩样品250块（以沙河街组为主）,在模拟储层条件下利用脉冲穿透法测试样品的纵、横波速度。样品在纵波速度一泊松比交汇图中表现出两种主要变化趋势,分别对应泥质与钙质胶结物的影响;在每个变化趋势中随泥质含量与钙质胶结物含量的增加,岩石结构从颗粒所构成的骨架支撑逐渐表现为基质支撑,弹性波能量的传播也从通过颗粒接触边界转变为通过岩石基质传播,这是使砂岩样品测试结果表现出两种截然不同变化趋势的主要原因,为利用岩石物理特性从地震资料中提取岩石结构、沉积与成岩特征的信息提供了依据。     

不同晶体学平面对无取向电工钢电磁性能的贡献及其磁性各向异性

论证了不同晶体学平面对无取向电工钢电磁性能的贡献及其磁性各向异性。结果表明,不同晶面的这两项指标均与它们在极图上的位置有关,13个重要晶面对无取向电工钢磁感应强度的贡献依照以下次序降低：{100}-{310}-{411}-{521}-{210}-{110}、{431}、{321}和{211}-{221}-{332}-{433}-{111};而磁性各向异性则以{110}晶面最强,{111}晶面最弱,{111}晶面及其他晶面的磁性各向异性以{110}晶面的极点为中心呈放射递减状分布在反极图上。     

融合复小波特征和局部二值模式的纹理聚类

为了解决图像检索中聚类问题,对图像作双树旋转复小波变换,再对变换后的系数通过广义高斯模型建模后,计算Kullback-Leibler距离;对图像采用局部二值模式,计算图像之间的对数似然距离.将这2种距离采用事先计算得到的加权因子进行融合得到新的距离.在此距离的基础上构建邻接矩阵,对邻接矩阵采用谱聚类的方法进行聚类运算.实验证明,由于双树旋转复小波变换和局部二值模式之间存在互补性,在聚类过程中将2种特征距离结合起来,能够有效地提高聚类的正确性.     

扇贝柱质构分析的测试条件

研究了扇贝柱质构分析(TPA)的测定方法.考察了TPA测定时扇贝柱适宜的预处理方法,比较了压缩程度、压缩速率对扇贝柱TPA特性参数硬度、弹性、凝聚性、咀嚼性和回复性的影响.研究结果表明,压缩程度对扇贝柱咀嚼性之外的TPA特性参数影响显著,压缩速率对其影响不显著.最终确定扇贝柱的适宜预处理条件为温度70℃,时间12 mi...